Password policies are already set to default.Īll account passwords have been successfully set to factory default. Passwd: Authentication token manipulation errorĪfter logon we can use “passworddefault” to reset to default password Or Factory password will result in fabric downtime. Passwords are documented in a secure location. Warning: Access to the Root and Factory accounts may be required for Here, press “Control + C” to exit or press “Enter” to change password Use Control-C to exit or press 'Enter' key to proceed. Please change passwords for switch default accounts now. Proceeding with the usage of this switch as the Root or Factory userĮxplicitly indicates your agreement to the terms of this disclaimer. The Equipment vendor's authorized engineers. Or damages arising from or relating to the use of the Root or FactoryĪccount (and the functionality enabled thereby) by anyone other than The Equipment vendor shall have no liability for any losses Your use of the functionality made available through the Root or FactoryĪccount is at your sole risk and you assume all liability resulting from Improper use of theįunctionality made available through the Root or Factory account couldĬause significant harm and disruption to the operation of the SAN fabric. The Equipment vendor's trained engineers. Chapter 3, Brocade VDX 6740 Configuration lays out the tasks and commands necessary to get the switch up and.
If the switch is not powered on until after it is connected to the fabric and the default domain ID is already in use, the domain ID for the new switch is automatically reset to a unique value.
#Set management ip brocade san switch install#
Chapter 2, Brocade VDX 6740 Installation provides the information needed to install the switch into your network. Log in to the switch through Telnet using the admin account. That are intended for diagnostics and debugging purposes solely by Chapter 1, Brocade VDX 6740 Introduction provides an overview of the Brocade VDX 6740 switch. This Fibre Channel switch is equipped with Root and Factory accounts These are the info printed when you logon the root account:ĭisclaimer for Root and Factory Accounts Usage! The OS of brocade switch uses Linux 2.6 kernel. The default password of “admin” is “password”. And use the root account to reset password under CLI. We have to use a console cable to connecting the switch. Connect to the switch and log in using an account assigned to the admin role. So, it’s necessarily to reset the password. Below are the steps performed to change the IP address of a switch via remote access: 1. We can’t log on the device if we forgot the password of admin.
0 kommentar(er)
